Live updated to 5.5. Audio and quest lines are broken.
Beta updated to 5.5.54.
(test)锻造流程及问题自检
(test)锻造流程及问题自检Name(test)锻造流程及问题自检
Type (Ingame)Quest Item
FamilyNon-Codex Series, Non-Codex Lore Item
RarityRaritystr

Item Story

1. Pre-Startup Preparation
Step 1: Before initiating the pressing process, the operator should wear protective gear at all times and perform a comprehensive equipment inspection.
Step 2: Before starting up the equipment, the operator must ensure the stock has been placed correctly to prevent mechanical damage to the equipment due to idling.
Step 3: Check the equipment's energy supply system to ensure that the equipment can run within normal parameters.
Once the above inspection steps have been completed, the pressing process can be initiated at the terminal.

2. Pressing Process Operation
When the pressing process is activated, the press will cause the stock to enter an activated state. You need to activate the press when the stock is giving off an orange-red light. Operating the press with the hammers can effectively induce deformation, so the operator must pay close attention to the state of the stock at all times during operation and manually operate the press with the hammers with the right timing.

3. Troubleshooting
To facilitate the operator's self-inspection, a fail-safe system has been installed on the base of currently available equipment models. The operator can troubleshoot system problems based on the errors reported by the fail-safe system. For more detailed instructions, please consult the "Emergency Response Handbook: 3rd Edition".

Leave a Reply

Your email address will not be published. Required fields are marked *

The Question at New in 5.6

Added Kaz to the chronicled wish, wonder why? He seems like he’s always in demand/still incredibly ...

The Real Amazon at Ifa

If he is good, then my shit is gold.

Sabre at Escoffier

Didn’t her c1 use to increase hydro crit dmg also?

TopButton
Discord Twitter Spiral Abyss Ganyu Discord Bot